Electrical power UNITS FOR LIFT TABLE 1
Basic Description
This electrical power unit is developed solely for the compact lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit has been extensively employed during the business of logistic products for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled from the solenoid valve together with the pace managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This power unit is intended solely for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve along with the pace controlled by the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is lower, the reducing movement is managed by the manual override perform.
Energy UNITS FOR LIFT TABLE 3
Standard Description
This energy unit is created solely to the big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve plus the speed managed by a strain compensated movement management valve.
Energy UNITS FOR LIFT TABLE four
Common Description
This energy unit is created solely for your significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and the pace managed through the adjustable needle valve. Once the lift rises to a high positoin, but the energy supply is minimize, the decreasing motion is managed by the manual override function.
Exclusive Notes
one. This energy unit is of S3 duty cycle, which might only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic parts concerned just before installation of the electrical power unit.
three. Viscosity on the oil shoud be 15~46 cst,which must also be clean and no cost of impurities.N46 hydraulic oil is advised.
4. Oil changing is needed right after the original a hundred operation hrs,afterwards after just about every 3000 hrs.
five. The energy unit shown is built to be mounted vertically.