Select Page

C Variety Flex-Flex Couplings
The C Form coupling includes two flex hubs, one particular sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Sort coupling include one flex hub, 1 rigid hub, 1 sleeve, a single accessory kit consisting of seals and snap rings.
Capabilities
Very simple and cheap kind of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Obtainable as vertical and horizontal couplings
Wide selection of exclusive variations such as full-flex, flex-rigid mill motor
Typical configurations can be found of the shelf
Ordering Information and facts
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical and so on.
Energy: Motor horspower or torque necessity.
Speed: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Info
Puller Holes are typical on sizes 4 by way of 12.
Puller Holes can be found for sizes 7/8 as a result of three.5 at an extra charge.
The BSE (distance In between Shaft Ends) may perhaps vary in between G and G1.
Interference bores with no set screws are normal except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, talk to Engineering Section.
Larger sizes are available, please check with Technical Help.